Pim Configuration Commands; Bsr-Policy - 3Com 5500G-EI Command Reference Manual

262 C 7: U
HAPTER SING
PIM Configuration
Commands

bsr-policy

M P C
ULTICAST ROTOCOL OMMANDS
Parameter
All IGMP groups.
all:
interface interface-type interface-number:
number.
group-address:
Mask of IGMP group address.
group-mask:
Description
Use the
reset igmp group
interface. The deleted group can added again on the interface.
Example
Delete all IGMP groups on all the interfaces.
<SW5500>reset igmp group all
Delete all IGMP groups on the Vlan-interface10.
<SW5500>reset igmp group interface Vlan-interface10 all
Delete the group 225.0.0.1 from the Vlan-interface10.
<SW5500>reset igmp group interface Vlan-interface10 225.0.0.1
Delete the IGMP groups ranging from 225.1.1.0 to 225.1.1.255 on the
Vlan-interface10.
<SW5500>reset igmp group interface Vlan-interface10 225.1.1.0
255.255.255.0
This section describes how to use the Protocol Independent Multicast (PIM)
configuration commands on your Switch 5500G-EI.
Syntax
bsr-policy acl-number
undo bsr-policy
View
PIM View
Parameter
ACL number imported in BSR filtering policy, in the range of 2000 to
acl-number:
2999.
Description
Use the
bsr-policy
spoofing.
IGMP group address.
command to delete an existing IGMP group from the
command to limit the range of legal BSRs to prevent BSR
Interface type and interface