Idle-Cut; Level - 3Com 5500G-EI Command Reference Manual

366 C 11: U
HAPTER SING

idle-cut

level

AAA RADIUS C
AND OMMANDS
Syntax
idle-cut { disable | enable
View
ISP Domain View
Parameter
means disabling the user to use idle-cut function .
disable:
means enabling the user to use the function.
enable:
Specifies the maximum idle time, ranging from 1 to 120 and measured in
minute :
minutes.
The minimum data traffic, ranging from 1 to 10,240,000 and measured in
flow :
bytes.
Description
Use the
idle-cut
domain.
By default, after an ISP domain is created, this attribute in user template is
, that is, the user idle-cut is disabled.
disable
The user template is a set of default user attributes. If a user requesting for the
network service does not have some required attributes, the corresponding
attributes in the template will be endeavored to him as default ones. The user
template of the Switch you are using may only provide user idle-cut settings. After
a user is authenticated, if the idle-cut is configured to enable or disable by neither
the user nor the RADIUS server, the user will adopt the idle-cut state in the
template.
Because a user template only works in one ISP domain, it is necessary to configure
user template attributes for users from different ISP domain respectively.
Related command:
Example
To enable the user in the current ISP domain, 3Com163.net, to use the idle-cut
attribute specified in the user template (that is, enabling the user to use the
idle-cut function). The maximum idle time is 50 minutes and the minimum data
traffic is 500 bytes.
<SW5500> system-view
System View: return to User View with Ctrl+Z.
[SW5500]domain marlboro.net
[SW5500-isp-marlboro.net]idle-cut enable 50 500
Syntax
level
level
undo level
minute flow
command to configure the user template in the current ISP
domain
}