Ip Routing Policy Configuration Commands; Apply Cost - 3Com 5500G-EI Command Reference Manual

220 C 6: U
HAPTER SING
IP Routing Policy
Configuration
Commands

apply cost

R P C
OUTING ROTOCOL OMMANDS
password
simple
eight characters or less. This must equal the authentication key of the virtually
linked neighbor.
Enter the MD5 authentication key ID, in the range 1 to 255. This must
keyid
md5
be equal to the authentication key ID of the virtually linked peer.
: Specify the MD5 authentication key. If it is input in a plain text form, the key
key
is a character string not exceeding 16 characters. It will be displayed in a cipher
text form in a length of 24 characters when display current-configuration
command is executed. Inputting the MD5 key in a cipher text form with 24
characters is also supported.
Description
Using the
vlink-peer
Using the
undo vlink-peer
RFC2328 states that an OSPF area must be connected to the backbone network.
You can use
vlink-peer
have a direct connection to the backbone area. A virtual link can also be used to
connect a discontiquous backbone. Virtual link can be regarded as a common
interface that uses OSPF so that you can easily understand how to configure
parameters such as
When configuring virtual link authentication, use the
command to set the authentication type to MD5 cipher text or plain text on the
backbone network.
Related commands:
Example
To create a virtual link to 10.110.0.3, and use the MD5 cipher authentication
mode, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]router id 1.1.1.1
[SW5500]ospf
[SW5500-ospf-1]area 10.0.0.0
[SW5500-ospf-1-area-10.0.0.0]vlink-peer 10.110.0.3 md5 3 345
This section describes the commands you can use to configure IP Routing Policy.
These commands operate across all routing protocols.
When the Switch 5500 runs a routing protocol, it is able to perform the functions
of a router. The term router in this section can refer either to a physical router or to
the Switch 5500 running a routing protocol.
Syntax
apply cost value
undo apply cost
Enter the simple text authentication key of the interface, in
command, you can create and configure a virtual link.
command, you can cancel an existing virtual link.
command to set up this connectivity if an area does not
, , and
hello retransmit
authentication-mode
.
trans-delay
authentication-mode
, .
display ospf