buffersize:
channel:
channel-number:
ten channels.
channel-name:
Description
Use the
buffer. Use the
information to trap buffer.
By default, output information is transmitted to trap buffer and size of trap buffer
is 256.
This command takes effect only after the system logging is enabled.
Related commands:
Example
Send information to the trap buffer and sets the size of buffer as 30.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]info-center trapbuffer size 30
[SW5500]
reset logbuffer
Syntax
reset logbuffer
View
User view
Parameter
None
Description
Use the
Example
Clear information in log buffer.
<SW5500>reset logbuffer
reset trapbuffer
Syntax
reset trapbuffer
View
User view
Size of trap buffer (numbers of messages).
Configure the channel to output information to trap buffer.
Channel number, ranging from 0 to 9, that is, the system has
Specify the channel name.
info-center trapbuffer
undo info-center trapbuffer
info-center enable
command to clear information in log buffer.
reset logbuffer
command to output information to the trap
command to cancel output
,
display info-center
Log Commands
471
.