Ftp Client Commands; Ascii - 3Com 5500G-EI Command Reference Manual

FTP Client Commands

Specifies the user's service type as FTP.
ftp:
ftp-directory
Optional.
Specifies user type to lan-access, which mainly refers to Ethernet
lan-access:
accessing users, 802.1x supplicants for example.
: Authorizes the user to use the terminal service (login from the Console,
terminal
AUX or Asyn port).
Description
Use the
service-type
Use the
undo service-type
type for a particular user.
If configuring service types: SSH, Telnet or Terminal:
When you configure a new service type for a user, the system adds the new
service type to the existing one.
You can set user level when you configure a service type. If you set multiple service
types and specify the user levels, then only the last configured user level is valid.
Different service type does not have its individual user level.
You can use either
local user. If both of these two commands are used, the latest configuration will
take effect.
Example
To configure a service type of LAN access for the user guest, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]local-user-guest
[SW5500-luser-guest]service-type lan-access
This section describes the File Transfer Protocol (FTP) Client commands on your
Switch 5500G-EI.

ascii

Syntax
ascii
View
FTP Client view
Parameter
None
Description
Use the
ascii
Enter an FTP directory, up to 64 characters in length.
directory
:
command to configure a service type for a particular user.
command to cancel the currently configured service
or
level service-type
command to configure data transmission mode as ASCII mode.
FTP Client Commands
command to specify the level for a
421