Mirroring-Port - 3Com 5500G-EI Command Reference Manual

cpu:
interface {
the destination port where the traffic will be mirrored to.
the port number.
name together.
Description
Use the
traffic mirroring.
Use the
This command is used for mirroring the traffic matching the specified ACL (whose
action is permit). The observing port cannot be a Trunk port or aggregated port.
This command only supports one observing port. When you use the traffic mirror
for the first time, you have to designate the observing port.
Related command:
Example
To mirror the packets matching the ACL 2000 rules, whose action is permit, to the
port Ethernet1/0/1, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500]interface gigabitethernet 1/0/1
[SW5500-GigabitEthernet1/0/1]monitor-port
[SW5500-GigabitEthernet1/0/1]quit
[SW5500]interface gigabitethernet 1/0/2
[SW5500-GigabitEthernet1/0/2]mirrored-to ip-group 2000
monitor-interface
SW5500-GigabitEthernet1/0/2]

mirroring-port

Syntax
mirroring-port { inbound | outbound | both }
undo mirroring-port
View
Ethernet Port View
Parameter
None
Description
Use the
Use the
The Switch supports one monitor port and one mirroring port. If several Switches
form a Fabric, only one monitor port and one mirroring port can be configured in
Specifies the traffic will be mirror to CPU
interface-name | interface-type interface-num
interface-num
interface-name
command to enable ACL traffic identification and perform
mirrored-to
undo mirrored-to
display qos-interface mirrored-to
command to configure a mirroring port.
mirroring-port
undo mirroring-port
QoS Configuration Commands List
and
interface-type
is
interface-type
command to disable traffic mirroring.
command to remove setting of mirroring port.
Specifies
}:
specifies
interface-num
specify a complete port
added with
interface-num
.
297
.