Display Arp - 3Com 5500G-EI Command Reference Manual

110 C 5: U N
HAPTER SING

display arp

P C
ETWORK ROTOCOL OMMANDS
Table 9 Output Description of the
Field
operation
sender_eth_addr
sender_ip_addr
target_eth_addr
target_ip_addr
Syntax
display arp [
text
| exclude }
View
All views
Parameters
Enter to display the dynamic ARP entries in the ARP mapping table.
dynamic
Enter to display the static ARP entries in the ARP mapping table.
static
Enter to start displaying from the first ARP entry that contains the specified
begin
character string "text".
Enter to display only the ARP entries that contain the specified character
include
string "text".
Enter to display only the ARP entries that do not contain the specified
exclude
character string "text".
Enter a character string. The ARP entries that contain this character string are
text
displayed.
Description
Use the
display arp
entry type, or by a specified IP address.
Related commands:
Example
To display all ARP entries in the mapping table, enter the following:
<SW5500>display arp
Type: S-Static
IP Address
161.71.61.20 0020-9c08-e774
--- 1 entry found
<SW5500>
debugging arp packet
Description
Type of ARP packets: 1 ARP request packet; 2 ARP reply packet
Ethernet address of the sender
IP address of the sender
Target Ethernet address. If the packet is ARP request packet, the target IP
address will be 0
Target IP address
ip-address
| [ dynamic | static ] [ | { begin | include
]]
command to display the ARP mapping table entries by
,
arp static reset arp
D-Dynamic
MAC Address VLAN ID
1
---
Command
.
Port Name / AL ID Aging Type
GigabitEthernet2/0/6 20 D