Snmp-Agent Target-Host - 3Com 5500G-EI Command Reference Manual

snmp-agent target-host

Description
Use the
snmp-agent sys-info
geographical location of the device, contact information for system maintenance
and version information of running SNMP. Use the
command to restore the default value.
location
Example
Set system location as Building 3/Room 214.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]snmp-agent sys-info location Building 3/Room 214
Syntax
snmp-agent target-host trap address udp-domain
udp-port-number ] params securityname
v3 [ authentication | privacy ] ]
undo snmp-agent target-host
View
System view
Parameter
Specifies the host to receive traps or notifications
trap:
Specifies the transport address to be used in the generation of SNMP
address:
messages.
Specifies the transport domain over UDP for the target address.
udp-domain:
Enter the IP address of the destination host.
host-addr
:
udp-port-number:
udp-port
the SNMP notification.
Specifies the SNMP target information to be used in the generation of
params:
SNMP messages.
Enter the community name, up to 32 characters in length.
community-string:
Specifies SNMP version 1.
v1:
Specifies SNMP version 2C.
v2c:
Specifies SNMP version 3.
v3:
Specifies that the packet is authenticated without encryption.
authentication:
Specifies that the packet is authenticated and encrypted.
privacy:
Description
Use the
snmp-agent target-host
you want to receive SNMP notification.
SNMP Configuration Commands
command to set system information such as
undo snmp-agent sys-info
community-string
host-addr
securityname
Enter the UDP port number of the host to receive
command to select and configure the host that
485
host-addr
[ udp-port
[ v1 | v2c |
community-string