Display Qos-Interface All - 3Com 5500G-EI Command Reference Manual

display qos-interface all

display qos-interface
line-rate
Syntax
display qos-interface { i
interface-num | unit-id
View
All views
Parameter
interface-name | interface-type interface-num
For more information, refer to the
: Unit ID of the Switch.
unit-id
Description
Using the
display qos-interface { i
interface-num | unit-id
interfaces. If you do not input interface parameters, this command will display all
QoS setting information for the Switch, including traffic policing, rate limit at
interface, and so on. If you input interface parameters, this command will display
QoS setting information of the specified interfaces, including traffic policing, rate
limit at interfaces, and so on.
Example
Display all the configurations of QoS parameters for unit 1.
<SW5500> display qos-interface 1 all
GigabitEthernet1/0/1: traffic-limit
Inbound:
Matches: Acl 2000 rule 1 running
Target rate: 128 Kbps
GigabitEthernet1/0/1: traffic-priority
Inbound:
Matches: Acl 2000 rule 1 running
Priority action: cos best-effort
GigabitEthernet1/0/1: line-rate
Outbound: 128 Kbps
GigabitEthernet1/0/1: traffic-statistic
Queue scheduling mode: weighted round robin
weight of queue 1: 1
weight of queue 2: 2
weight of queue 3: 3
weight of queue 4: 4
weight of queue 5: 5
weight of queue 6: 6
---- More ----
Syntax
display qos-interface {
interface-num | unit-id
QoS Configuration Commands List
nterface-name | interface-type
} all
command in this manual.
port
nterface-name | interface-type
command, you can view QoS information of all
} all
interface-name | interface-type
} line-rate
: Interfaces of the Switch.
291