Port Trunk Permit Vlan - 3Com 5500G-EI Command Reference Manual

64 C 2: U P
HAPTER SING ORT

port trunk permit vlan

C
OMMANDS
Description
Use the
port link-type
port. Use the
undo port link-type
status. By default, a port is an access port.
A port on a Switch can be configured as an access port, a hybrid port, a trunk port
or a fabric port. However, to reconfigure between hybrid and trunk link types, you
must first restore the default, or access, link type.
Example
To configure the Ethernet port Ethernet1/0/1 as a trunk port, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface Gigabitethernet 1/0/1
[SW5500-GigabitEthernet1/0/1]port link-type trunk
Syntax
port trunk permit vlan {
undo port trunk permit vlan {
View
Ethernet port view
Parameter
Enter a VLAN ID, or more than one VLAN ID, in the range 1 to 4094.
vlan_id:
The trunk port will be added to the specified VLANs. This can be a single VLAN, a
series of individual VLANs separated by a space, or the first VLAN in a range of
VLANs. If this is the first VLAN in a range use the
indicate the last VLAN in the range (
You can enter up to ten
command.
Enter to add the trunk port to all VLANs.
all:
Description
Use the
port trunk permit vlan
selection of VLANs or all VLANs. Use the
command to remove a trunk port from one VLAN, a selection of VLANs or all
VLANs.
A trunk port can belong to multiple VLANs. If the
command is used many times, then the VLAN enabled to pass on trunk port is the
set of these
vlan_id_list
Related command:
command to configure the link type of the Ethernet
command to restore the port as default
vlan_id_list
vlan_id_list
vlan_id
parameters at one
vlan_id
command to add a trunk port to one VLAN, a
undo port trunk permit vlan
.
.
port link-type
| all}
| all}
parameter to
last_vlan_id
).
last_vlan_id
to
port trunk permit vlan
port trunk permit vlan