Command-Privilege Level - 3Com 5500G-EI Command Reference Manual

command-privilege level

undo auto-execute command
View
User Interface View
Parameter
Specifies the command to be run automatically.
text:
Description
Enter
auto-execute command
a specified command. When the user logs in, the command will be executed
automatically. This command is usually used to configure the
the terminal, which will connect the user to a designated device automatically.
Enter
undo auto-execute command
command is not run automatically.
By default, auto-execute is disabled.
CAUTION: If you execute this command, the user-interface can no longer be used
to perform routine configurations on the local system. Ensure that you can log in
to the system in some other way to cancel the configuration, before you configure
the
auto-execute command
Example
To configure the Switch to automatically Telnet to device 10.110.100.1 after the
user logs in via VTY 0, enter the following command:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]user-interface vty 0
[SW5500-ui-vty0]auto-execute command telnet 10.110.100.1
Syntax
command-privilege level
undo command-privilege view
View
System View
Parameter
Enter the command level you want to assign to this command, ranging
level:
from 0 to 3.
Enter the name of the view that contains the command. This can be any of
view:
the views supported by the Switch.
Enter the command to be configured.
command:
Description
Use the
command-privilege level
assigned to any command within a selected view.
to configure the Switch to automatically run
text
to cancel the auto-execute command so the
and save the configuration.
level view
view command
view command
command to configure the priority level
Logging in Commands
command on
telnet
25