Ospf Mtu-Enable; Ospf Network-Type - 3Com 5500G-EI Command Reference Manual

ospf mtu-enable

ospf network-type

Cancel the binding of MIB operation.
[SW5500]undo ospf mib-binding
Syntax
ospf mtu-enable
undo ospf mtu-enable
View
VLAN Interface view
Parameter
None
Description
Using the
ospf mtu-enable
MTU value when sending DD packets.
Using the
undo ospf mtu-enable
default, the MTU value is 0 when sending DD packets, that is the MTU value of the
interface is not written.
DD packets (Database Description Packet) are sent by the router to describe its
own LSDB when the router running OSPF protocol is synchronizing the database.
Example
To set interface Vlan-interface 3 to write the MTU value when sending DD packets,
enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface Vlan-interface 3
[SW5500-Vlan-interface 3]ospf mtu-enable
Syntax
ospf network-type { broadcast | nbma | p2mp | p2p }
undo ospf network-type
View
VLAN Interface View
Parameter
Change the interface network type to broadcast.
broadcast
Change the interface network type to NBMA.
nbma
Change the interface network type to p2mp.
p2mp
Change the interface network type to point-to-point.
p2p
OSPF Configuration Commands
command, you can enable the interface to write the
command, you can restore the default. By
209