Default Interval; Default Limit - 3Com 5500G-EI Command Reference Manual

OSPF Configuration Commands 181
Example
To specify a default routing cost of 10 for an external route imported by OSPF,
enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]router id 1.1.1.1
[SW5500]ospf
[SW5500-ospf-1]default cost 10

default interval

Syntax
seconds
default interval
undo default interval
View
OSPF View
Parameter
Enter the default interval, in seconds, for redistributing external routes.
seconds
This can be in the range 1 to 2147483647. The default is 1 second.
Description
Use the command to configure the default interval for OSPF to
default interval
import external routes.
Use the command to restore the default value of 1
undo default interval
second.
Because OSPF can import external routing information and broadcast it to the
entire autonomous system, and importing routes can affect the performances of
the device (depending on the number of external routes being imported), it is
necessary to specify the default interval for the protocol to import external routes.
Example
To specify a default interval of 10 seconds for OSPF to import external routes,
enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]router id 1.1.1.1
[SW5500]ospf
[SW5500-ospf-1]default interval 10

default limit

Syntax
default limit routes
undo default limit
View
OSPF View