Spf-Schedule-Interval; Stub - 3Com 5500G-EI Command Reference Manual

218 C 6: U R
HAPTER SING

spf-schedule-interval

stub

P C
OUTING ROTOCOL OMMANDS
This command cannot be applied to the OSPF processes that are started after the
command is executed.
By default, the switch does not send TRAP packets in case of OSPF anomalies.
For detailed configuration of SNMP TRAP, see
Commands" on
Example
Enable the TRAP function for OSPF process 100.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]snmp-agent trap enable ospf 100
Syntax
spf-schedule-interval
undo spf-schedule-interval
View
OSPF View
Parameter
Enter the SPF route calculation interval for OSPF, in seconds, in the range
interval
1 to 10. The default value is 5 seconds.
Description
Using the
spf-schedule-interval
calculation interval of OSPF.
Using the
undo spf-schedule-interval
setting.
According to the Link State Database (LSDB), the router running OSPF can
calculate the shortest path tree, with itself as the root, and determine the next hop
to the destination network according to the shortest path tree. By adjusting the
SPF calculation interval, you can decrease the frequency of network changes and
unnecessary consumption of bandwidth and router resources.
Example
To set the OSPF route calculation interval of the Switch 5500 to 6 seconds, enter
the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]router id 1.1.1.1
[SW5500]ospf
[SW5500-ospf]spf-schedule-interval 6
Syntax
stub [ no-summary ]
undo stub
page 397.
interval
command, you can configure the route
"Using System Management
command, you can restore the default