Info-Center Console Channel; Info-Center Enable - 3Com 5500G-EI Command Reference Manual

462 C 12: U S M C
HAPTER SING YSTEM ANAGEMENT OMMANDS
Description
Use the command to rename a channel specified by
info-center channel name
the as . Using the u
channel-number channel-name. ndo info-center channel
, you can restore the channel name.
command
Note that the channel name cannot be duplicated.
Example
Rename channel 0 as execconsole.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]info-center channel 0 name execconsole
info-center console Syntax
channel
channel-number channel-name

info-center console channel {

| }
undo info-center console channel
View
System view
Parameter
Channel number, ranging from 0 to 9, that is, system has ten
channel-number:
channels.
: Specify the channel name. The name can be
channel-name: channel6,
channel7, channel8, channel9, console, logbuffer, loghost, monitor,
snmpagent, trapbuffer.
Description
Use the command to configure the channel
info-center console channel
through which the log information is output to the console.
By default, the Switch 5500G-EI does not output log information to the console.
This command takes effect only after system logging is started.
For the related commands, see , .

info-center enable

display info-center
Example
Configure to output log information to the console through channel 0.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]info-center console channel 0
info-center enable Syntax
info-center enable
undo info-center enable