Dot1X Port-Control - 3Com 5500G-EI Command Reference Manual

dot1x port-control

Parameter
Specifies the limit to the amount of supplicants on the port,
user-number
:
ranging from 1 to 1024.
By default, the maximum user number is 1024.
interface-list
interface
interfaces, expressed in the format
interface-num
] } & < 1-10 >
interface in the format
, where interface-type specifies the interface type,
interface-name }
specifies the interface number and
interface-num
interface name. For the respective meanings and value ranges, see the parameters
in the Port Command chapter.
Description
Use the
dot1x max-user
supplicants on the specified interface using 802.1x. Use the
command to restore the default value.
max-user
This command is used for setting a limit to the amount of supplicants that 802.1x
can hold on the specified interface. This command takes effect on the interface
specified by the parameter
takes effect on all the interfaces when no interface is specified. The parameter
cannot be entered when the command is executed in Ethernet
interface-list
Port View and it takes effect only on the current interface.
Related command:
display dot1x
Example
Configure the interface GigabitEthernet 1/0/1 to hold no more than 32 users.
<SW5500>system-view
System View: return to User View with Ctrl-Z
[SW5500]dot1x max-user 32 interface gigabitethernet 1/0/1
Syntax
dot1x port-control { auto | authorized-force | unauthorized-force-}
interface-list
[ interface
undo dot1x port-control [ interface
View
Ethernet Port View
Parameter
Automatic identification mode, configuring the initial state of the interface
auto:
as unauthorized. The user is only allowed to receive or transmit EAPoL packets but
not to access the network resources. If the user passes the authentication flow, the
interface will Switch over to the authorized state and then the user is allowed to
access the network resources. This is the most common case.
Ethernet interface list including several Ethernet
:
interface-list
.
interface-num
interface-num interface-type interface-num
= {
command to configure a limit to the amount of
when executed in System View. It
interface-list
.
]
interface-list
802.1x Configuration Commands
= { interface-num
specifies a single Ethernet
interface-name
undo dot1x
]
347
[ to
|
specifies the