3Com 5500G-EI Command Reference Manual page 148

148 C 6: U R
HAPTER SING
P C
OUTING ROTOCOL OMMANDS
Routes matched by access-list 2000:
Summary count: 4
Destination/Mask
10.1.1.0/24
10.1.1.2/32
For detailed description of the output information, see
To display the verbose information of the active and inactive routes that are
filtered through basic ACL 2000.
<SW5500>display ip routing-table acl 2000 verbose
The information displays in the following format:
Routes matched by access-list 2000:
Generate Default: no
+ = Active Route, - = Last Active, # = Both* = Next hop in use
Summary count:2
**Destination: 10.1.1.0
Protocol: #DIRECT
*NextHop: 10.1.1.2
Vlinkindex: 0
State: <Int ActiveU Retain Unicast>
Age: 7:24 Cost: 0/0 Tag: 0
**Destination: 10.1.1.2
Protocol: #DIRECT
*NextHop: 127.0.0.1
Vlinkindex: 0
State: <NoAdvise Int ActiveU Retain Gateway Unicast>
Age: 7:24 Cost: 0/0 Tag: 0
Table 18 Output Description of the
Field
Destination
Mask
Protocol
Preference
Nexthop
Interface
Vlinkindex
Protocol Pre
DIRECT 0
DIRECT 0
Mask: 255.255.255.0
Preference: 0
Interface: 10.1.1.2(Vlan-interface1)
Mask: 255. 255. 255. 255
Preference: 0
Interface: 127.0.0.1(InLoopBack0)
ip routing-table acl verbose
Description
Destination address
Mask
Routing protocol
Routing preference
Next hop address
Output interface, through which the data packet destined for the
destination network is sent
Virtual link index
Cost Nexthop Interface
0 10.1.1.21 Vlan-interface1
0 127.0.0.1 InLoopBack0
Table 18.
Command