3Com 5500G-EI Command Reference Manual page 234

234 C 6: U R
HAPTER SING
P C
OUTING ROTOCOL OMMANDS
Parameter
safety_value
safety
Mbytes. Its value range depends on the idle memory of the active Switch. The
default value is 4Mbytes.
limit_value
limit
value range depends on the idle memory of the active Switch. The default value is
2Mbytes.
Description
Use the
memory limit
Switch idle memory. When the idle memory of the Switch is less than this limit, all
the routing protocol connections will be disconnected forcibly. The
in the command must be less than the current idle memory safety value or the
configuration will fail.
Use the
memory safety
the Switch idle memory. If you use the
command (the default configuration), the routing protocol connection that is
forcibly disconnected will automatically recover when the idle memory of the
Switch reaches this value. The
the current idle memory lower limit or the configuration will fail.
Use the
memory safety
both of the safety value and lower limit of the Switch idle memory. The
must be more than the
safety_value
Use the
memory default
limit of the Switch idle memory to the default configuration.
Related commands:
,
enable display memory limit
Example
Set the lower limit of the Switch idle memory to 1 Mbytes and the safety value to
3 Mbytes.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]memory safety 3 limit 1
%Jun 6 04:18:49:533 2000 SW5500 RM/5/RTLOG:- 1 -Change the system
memory limit (1->1)/safety(2->3) successfully
Enter the safety value of the Switch idle memory, in
Enter the lower limit of the Switch idle memory, in Mbytes. Its
command to configure the lower limit of the
limit_value
command to configure the safety value of
safety_value
memory auto-establish enable
safety_value
safety_value
limit
limit_value
command to configure the safety value and the lower
memory auto-establish disable
.
limit_value
in the command must be more than
command to change
limit_value
or the configuration will fail.
,
memory auto-establish