Arp Timer Aging - 3Com 5500G-EI Command Reference Manual

108 C 5: U N
HAPTER SING

arp timer aging

P C
ETWORK ROTOCOL OMMANDS
Enter the MAC address of the ARP mapping entry, in the format
mac_address
H-H-H (H indicates a four digit hexadecimal number, for example
00e0-fc01-0000).
Enter the ID number of the local VLAN that you want to use to associate
vlan_id
with the ARP mapping entry. The VLAN ID can be in the range 1 to 4094.
Optional.
interface_type
to this address. Optional, but must be entered if a VLAN ID is specified.
interface_number
frames to this address. Optional, but must be entered if a VLAN ID is specified.
Description
Use the
arp static
entries in the ARP mapping table. You must enter an IP address and MAC address
with this command. You can optionally enter a VLAN ID, which also requires entry
of an interface type and interface number. An aggregation port or port with LACP
enabled cannot be set as the egress port of static ARP.
Use the
undo arp
from the ARP table.
To remove all static ARP entries, use the
the
reset arp static
By default, the ARP mapping table is empty, and the Switch uses dynamic ARP to
maintain its address mapping.
Related commands:
Example
To associate the IP address 202.38.10.2 with the MAC address 00e0-fc01-0000,
and the ARP mapping entry to Ethernet1/0/1 on VLAN1, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]arp static 202.38.0.10 00e0-fc01-0000 1 gigabitEthernet1/0/1
Syntax
arp timer aging
undo arp timer aging
View
System View
Parameter
Enter the aging time of dynamic ARP aging timer, in the range 1 to
aging_time
1440 minutes. The default is 20 minutes.
Enter the type of the port that you want to use to send frames
Enter the number of the port that you want to use to send
command to manually configure the static ARP mapping
command to remove a static ARP mapping entry
ip_address
reset arp static
command removes all static ARP entries permanently.
,
reset arp display arp
aging_time
command. Note that
, .
debugging arp