Poe Enable; Poe Legacy Enable - 3Com 5500G-EI Command Reference Manual

poe enable

poe legacy enable

Description
Use the
display poe powersupply
power sourcing equipment (PSE).
Example
Display the PSE parameters.
[SW5500]display poe powersupply
PSE ID
PSE Legacy Detection
PSE Total Power Consumption :12000 mW
PSE Available Power
PSE Peak Value
PSE Average Value
PSE Software Version
PSE Hardware Version
PSE CPLD Version
PSE Power-Management mode
Syntax
poe enable
undo poe enable
View
Ethernet Port View
Parameter
None
Description
Use the command to enable the PoE feature on a port.
poe enable
Use the
undo poe enable
By default, the PoE feature on each port is enabled.
Example
Enable the PoE feature on the current port.
[SW5500-GigabitEthernet1/0/3]poe enable
Port power supply is enabled
# Disable the PoE feature on the current port.
[SW5500-GigabitEthernet1/0/3]undo poe enable
Port power supply is disabled
Syntax
poe legacy enable
undo poe legacy enable
PoE Configuration Commands
command to view the parameters of the
:1
:disable
:268000 mW
:12000 mW
:12000 mW
:290
:000
:021
:auto
command to disable the PoE feature on a port.
95