Register-Policy; Reset Pim Neighbor - 3Com 5500G-EI Command Reference Manual

276 C 7: U M
HAPTER SING

register-policy

reset pim neighbor

P C
ULTICAST ROTOCOL OMMANDS
Example
Configure to transmit Hello packet via VLAN-interface10 every 40 seconds.
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500]multicast routing-enable
[SW5500]interface Vlan-interface-10
[SW5500-vlan-interface10]pim timer hello 40
Syntax
register-policy
undo register-policy
View
PIM View
Parameter
Number of IP advanced ACL, defining the rule of filtering the source
acl-number :
and group addresses. The value ranges from 3000 to 3999.
Description
Use the
register-policy
messages sent by the DR in the PIM-SM network and to accept the specified
messages only.
Use the
undo register-policy
filtering.
Example
If the local device is the RP in the network, use the following command to only
accept multicast message register of the source sending multicast address in the
range of 225.1.0.0/16 on network segment 10.10.0.0/16.
<SW5500> system-view
System View: return to User View with Ctrl+Z
[SW5500] acl number 3010
[SW5500-acl-adv-3010] rule permit ip source 10.10.0.0 0.0.255.255
destination 225.1.0.0 0.0.255.255
[SW5500-acl-adv-3010] quit
[SW5500] pim
[SW5500-pim] register-policy 3010
Syntax
reset pim neighbor { all | {
interface-type interface-number
View
User View
Parameter
All PIM neighbors
all:
acl-number
command to configure a RP to filter the register
command to remove the configured message
neighbor-address
} * }
| interface