Public-Key-Code Begin - 3Com 5500G-EI Command Reference Manual

public-key-code begin

Supports only Telnet protocol.
telnet:
Description
Use the
protocol inbound
designated user interface.
By default, the system supports both Telnet and SSH protocols.
If SSH protocol is enabled and specified for the user interface, but no local RSA key
is configured, SSH cannot take effect yet till you log onto the system next time.
If SSH protocol is specified, to ensure a successful logon, you must configure the
AAA authentication using the
protocol inbound ssh
authentication-mode password
Related command:
user-interface vty
Example
Disable Telnet on vty0 through vty4, with only SSH available:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]user-interface vty 0 4
[SW5500-ui-vty0-4]protocol inbound ssh
Disable Telnet on vty0, with only SSH available.
<SW5500> system-view
System View: return to User View with Ctrl+Z.
[SW5500]user-interface vty 0
[SW5500-ui-vty0]protocol inbound ssh
Syntax
public-key-code begin
View
Public key edit view
Parameter
None
Description
Use the
public-key-code begin
Before using this command, you have to create a public key with the
command. In the public key edit view to key in desired public
peer-public-key
key, which consists of hexadecimal characters, with blank space allowed between
them, and is generated randomly by the client program supporting SSH.
Related commands:
rsa peer-public-key
Example
To enter public key view and key in public key, enter the following:
command to configure the protocols supported by a
authentication-mode scheme
configuration fails if you configure
and
authentication-mode none
.
command to enter public key edit view.
,
public-key-code end
SSH Configuration Commands
command. The
.
rsa
.
517