Local-User - 3Com 5500G-EI Command Reference Manual

AAA Configuration Commands 367
View
Local User View
Parameter
Specifies user priority level, an integer ranging from 0 to 3.
level :
Description
Use the command to configure user priority level. Use the
level undo level
command to restore the default user priority level.
By default, the user priority level is 0.
Related command:

local-user

If the configured authentication mode is none authentication or password
authentication, the command level that a user can access after login depends on
the priority of user interface. In the case of authentication requiring both
username and password, however, the accessible command level depends on user
priority level.
Example
To set the priority level of the user 3Com to 3, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]local-user 3Com1
[SW5500-luser-3Com1]level 3
local-user Syntax
local-user user-name
undo local-user { user-name | all [ service-type { telnet | ftp |
lan-access | ssh | terminal } ] }
View
System View
Parameter
Specifies a local username with a character string not exceeding 80
user-name :
characters, excluding "/", ":", "*", "?", "<" and ">". The @ character can only
be used once in one username. The pure username (the part before @, namely the
user ID) cannot exceed 55 characters. The parameter is not case
user-name
sensitive.
Specifies the service type.
service-type:
The specified user type is telnet.
telnet:
The specified user type is ftp.
ftp:
: The specified user type is lan-access which mainly refers to Ethernet
lan-access
accessing users, 802.1x supplicants for example.