Display Power; Display Schedule Reboot - 3Com 5500G-EI Command Reference Manual

display power

display schedule reboot

Example
To display the current memory status, enter the following:
<SW5500>display memory
The information displays in the following format:
System Total Memory(bytes): 32491008
Total Used Memory(bytes): 13181348
Used Rate: 40%
Table 55 Display information
Field
System Total Memory (bytes)
Total Used Memory (bytes)
Used Rate
Syntax
display power [ unit
View
All views
Parameter
: Specify the Unit ID of the switch
unit-id
unit
Power ID.
power-ID:
Description
Use the
display power
power supply.
Example
Show power state.
<SW5500>display power 1
Unit1
Power 1 State: Normal
Syntax
display schedule reboot
View
Any view
Parameter
None
Description
Use the
display schedule reboot
related parameters of the switch schedule reboot terminal service.
Device Management Commands
Description
The Total Memory of switch, unit in byte
The Total used Memory of switch, unit in byte
The memory used rate
unit-id power-ID
][
command to display the working state of the built-in
command to check the configuration of
]
439