ABB Robotics OmniCore C90XT Product Manual page 88

3 Installation and commissioning
3.5.8 Set up the network connection
Continued
Firewall settings
The Firewall Management function is used to configure the network firewall on the
controller. Configuration is done in RobotStudio under Configuration ->
Communication -> Firewall Manager where pre-configured Network Services can
be enabled or disabled:
xx1900000352
For more information, see Technical reference manual - System parameters.
Related information
See more information about network configuration in Operating manual - Integrator's
guide OmniCore.
88
Note
Only pre-registered Network Services can be configured in the Firewall Manager
settings. The user cannot add new Network Services in the Firewall Manager
and can only change the parameters Enable on Public Network and Enable on
Private Network for pre-registered Network Services.
Note
Only users with UAS grant Modify network security properties can modify the
firewall settings.
© Copyright 2020-2021 ABB. All rights reserved.
Product manual - OmniCore C90XT
3HAC073706-001 Revision: E