ABB Robotics OmniCore C90XT Product Manual page 61

Mounting the FlexPendant holder onto a flat surface (Horizontally)
Use this procedure to mount the FlexPendant holder onto a flat surface, like the
top of the controller, desktop and so on.
1
2
3
Hanging the FlexPendant holder with the bracket
Use this procedure to hang the FlexPendant holder on any place where can hold
the bracket, like the door of the controller.
Product manual - OmniCore C90XT
3HAC073706-001 Revision: E
Action
Clean the surface and make sure it is dry.
Remove the protective liner from the
tape.
Press the holder onto the desired place.
Tip
The bracket is included when the FlexPendant is purchased.
© Copyright 2020-2021 ABB. All rights reserved.
3 Installation and commissioning
3.4.2 Mounting the FlexPendant holder
Note/illustration
xx2000002352
xx2000002353
Continues on next page
Continued
61