ABB Robotics OmniCore C90XT Product Manual page 316

5 Repair
5.3.5 Replacing the HMI signal (FlexPendant) connector
Continued
5
6
7
Refitting the HMI signal connector
Refitting the HMI signal connector
1
2
Continues on next page
316
Action
Remove the attachment screws on the
door.
Push the HMI signal connector into the
cabinet.
Take the HMI signal connector out.
Action
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 30.
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 43.
© Copyright 2020-2021 ABB. All rights reserved.
Note/Illustration
xx1900001923
Note/Illustration
Location of wrist strap button:
xx1900001446
Product manual - OmniCore C90XT
3HAC073706-001 Revision: E