ABB Robotics OmniCore C90XT Product Manual page 62

3 Installation and commissioning
3.4.2 Mounting the FlexPendant holder
Continued
1
2
Hanging the front part of the FlexPendant holder with screws (Vertically)
Use this procedure to hang the front part of the FlexPendant holder to the desired
place.
1
2
3
Continues on next page
62
Action
Hang the FlexPendant holder to the
bracket according to the screws on the
bracket.
Hang the holder with the bracket to the
desired place.
Action
Remove the four screws.
Separate the rear part from the FlexPend-
ant holder.
Clean the surface and make sure it is dry.
© Copyright 2020-2021 ABB. All rights reserved.
Note/illustration
xx2000002354
xx2000002355
Note/illustration
xx2000002356
Product manual - OmniCore C90XT
3HAC073706-001 Revision: E