Table of Contents
Advertisement
7 Troubleshooting
7.3.6 Troubleshooting the connected services gateway
Continued
Description
RF, signal
strength status
LEDs
Required test equipment
Equipment needed for troubleshooting:
Equipment
Multimeter
Insulating gloves
Preparations
1
2
3
Continues on next page
396
Significance
Three (3) LEDs indicating the Wi-Fi or 3G signal level.
•
ON: The unit is connected to the network and working ok.
•
OFF: Problem with connector, antenna, or sim card.
Action
Check the FlexPendant for errors and warnings.
Power the controller off. Wait one minute, power the controller on.
Wait 30-60 seconds after power-on.
Make sure that the control system power is in run-time mode.
© Copyright 2020-2021 ABB. All rights reserved.
Note
Product manual - OmniCore C90XT
3HAC073706-001 Revision: E
Advertisement
Table of Contents
Troubleshooting
