ABB Robotics OmniCore C90XT Product Manual page 132

3 Installation and commissioning
3.7.6 Installing the fieldbus master
Continued
2
3
Installing the DeviceNet board
1
Continues on next page
132
Action
Pull the cable ties out from the locking
holes.
Remove the screws and lift out the robot
signal exchange proxy.
Action
ELECTROSTATIC DISCHARGE
(ESD)
When handling the computer outside of
the controller, use the wrist strap button
located on the side of the computer.
© Copyright 2020-2021 ABB. All rights reserved.
Note/Illustration
xx1900001879
xx1900001880
Note/Illustration
Location of wrist strap button:
xx2000000419
Product manual - OmniCore C90XT
3HAC073706-001 Revision: E