ABB Robotics OmniCore C90XT Product Manual page 84

3 Installation and commissioning
3.5.7 Network connections on OmniCore
Continued
Defining network settings
Network settings can be defined either in RobotStudio or from the FlexPendant
for the controller:
Continues on next page
84
Note
The Firewall Manager settings must be set to YES if the EtherNet/IP is to be used
on the public network. Configuration is done in RobotStudio under Configuration
-> Communication -> Firewall Manager. See Operating manual - Integrator's
guide OmniCore for more information.
• Defining network settings in RobotStudio:
1 In the Configuration browser, right-click the controller and select
Properties and then Network settings.
xx2000000488
2 In the Network settings window, set the values for:
- IP address: The IP address for the OmniCore controller on the
EtherNet network.
- Subnet mask: The subnet mask.
- Default gateway: The default gateway.
xx2000000489
© Copyright 2020-2021 ABB. All rights reserved.
Product manual - OmniCore C90XT
3HAC073706-001 Revision: E