ABB Robotics OmniCore C90XT Product Manual page 82

3 Installation and commissioning
3.5.7 Network connections on OmniCore
Continued
An I/O network that is local for a specific robot should be connected to the Ethernet
port LAN, I/O or the ETHERNET SWITCH on the controller.
Connections on the main computer
The Ethernet ports on the main computer belong to the following network segments:
Network Interface Network Interface
xx1800003053
Private Network
The ports X3 (MGMT), X6 (LAN 1), and X4 (LAN 2) and X2 (LAN 3) belong to the
Private Network segment.
The MGMT port shall be used by service personnel in close proximity to the
controller, with a single client connected to the controller.
The LAN1, LAN2 and LAN3 ports are intended for connecting robot controller
internal computers or network based process equipment to the controller, for
example cameras, and welding equipment.
Continues on next page
82
Note
It is not supported to connect multiple ports of the OmniCore controller to the
same external switch unless static VLAN isolation is applied on the external
switch.
Network segment Network segment Private Network
Service PC FlexPendant
MGMT, LAN1, LAN2, LAN3 MGMT, LAN1, LAN2, LAN3
IP con guration IP con guration Address: Address:
192.168.125.1 192.168.125.1
Note
Private Network segments of multiple robot controllers cannot be connected to
each other.
Note
The management port shall never be used for more than one client at a time.
ABB Robotics assumes no responsibility for any errors/hazards that may appear
when more than one client is attached to the management port.
© Copyright 2020-2021 ABB. All rights reserved.
Ability Network Ability Network
PLC Connected Services Connected Services
Gateway Gateway
Cameras,
sensors, I/O
LAN4 LAN4
Address: Address:
192.168.126.2 192.168.126.2
Product manual - OmniCore C90XT
Public Network Public Network Drive Network
Factory Network Factory Network Axis computer
WAN WAN
AXC AXC
Address: Address: Address: Address:
Speci ed in Speci ed in 192.168.127.1 192.168.127.1
Robot Studio Robot Studio
or on FlexPendant or on FlexPendant
3HAC073706-001 Revision: E