ABB Robotics OmniCore C90XT Product Manual page 317

3
4
5
6
Product manual - OmniCore C90XT
3HAC073706-001 Revision: E
5.3.5 Replacing the HMI signal (FlexPendant) connector
Action
Insert the HMI signal connector into the
cover from inside the cabinet.
Secure it with the screws.
Connect:
• TPU (X4) - K2.X9 & X13
Secure the cables on HMI signal connect-
or into the clips on the cabinet.
Tip
Use the same position as from removing
the HMI signal connector.
Refit the cover plate.
© Copyright 2020-2021 ABB. All rights reserved.
Note/Illustration
Screws: Torx, countersunk screw M4x10 (4
pcs)
xx1900001923
xx1900001922
Continues on next page
5 Repair
Continued
317