ABB Robotics OmniCore C90XT Product Manual page 411

9
10
Product manual - OmniCore C90XT
3HAC073706-001 Revision: E
Test
Check the cabling.
The power supply may be faulty,
replace it and verify that the fault
has been fixed.
© Copyright 2020-2021 ABB. All rights reserved.
7 Troubleshooting
7.3.10 Troubleshooting the power supply
Note
Make sure that the cabling is correctly connec-
ted and not faulty.
• If the cabling is OK, see
the power unit on page
the fault has been fixed and restart this
guide if necessary.
• If the cabling is found unconnected or
faulty, connect/replace it. Verify that the
fault has been fixed and restart this
guide if necessary.
See Replacing the power supply on page
Continued
Troubleshooting
388. Verify that
253.
411