ABB Robotics OmniCore C90XT Product Manual page 85

PROFINET on factory network
When the WAN port is used for connecting to an industrial network, the traffic
shares the same media as the factory network and will share bandwith with other
non industrial network traffic.
The following figure illustrates the network when connecting a controller and a
device to the WAN port of the main computer:
xx1900001102
Product manual - OmniCore C90XT
3HAC073706-001 Revision: E
• Defining network settings on the FlexPendant:
1 On the start screen, tap Settings, and then select Network from the
menu.
2 Define IP address for the controller and tap OK.
Factory Network & Industrial Network
Robot Controller 1
Private
MGMT LAN1 LAN2
Camera
© Copyright 2020-2021 ABB. All rights reserved.
3 Installation and commissioning
3.5.7 Network connections on OmniCore
PLC
PROFINET
Public
LAN3 WAN MGMT
Continued
Cell I/O
I/O I/O
Robot Controller 2
Private Public
LAN1 LAN2 LAN3 WAN
85