Gp 22 Special Boot Modes - Xerox VersaLink B7025 Service Manual

GP 22 Special Boot Modes

Purpose
To start the device in various modes to enable special functions.
Procedure
1. Switch off the machine, GP 10.
2. Simultaneously press then hold down the Home and Power buttons until the device pow-
ers on and SPECIAL BOOT MENU appears,
3. Simultaneously touch the letters A in SPECIAL, B in BOOT and the Home button. Do not
hold any of the three locations, just touch/press then release simultaneously,
Touch
Figure 1 Accessing special boot mode
4. At the keypad screen enter code number, 6789#. The first SPECIAL BOOT MENU screen
will display.
Do not switch off the device until the reboot is complete. The device will reboot after the down-
load is complete.
5. Scroll through the SPECIAL BOOT MENU screens to select the appropriate function,
refer to Table 1. Follow the on screen instructions. The device may reboot, then print a
report.
Table 1 Next level of menu
Function Display
DOWNLOAD MODE --BOOT MODE--
DOWNLOAD MODE
ARE YOU SURE?
YES
NO
LONGDIAG MODE --BOOT MODE--
LONGDIAG MODE
ARE YOU SURE?
YES
NO
General Procedures and Information
GP 22
Figure 1.
CAUTION
Notes
Machine starts in Firmware Download Mode.
Refer to GP 4.
Performs a more detailed check than the
usual device diagnostic items at machine
start. If a fault code is displayed, perform the
relevant procedure.
Function
01. JOB LOG
CLEAR MODE
02. FACTORY INIT
MODE
Figure 1.
03. NVRAM INIT
MODE
04. HDD FORMAT
MODE
06. HDD INITIALIZE
MODE
SKIP INSTALL WIZ-
ARD
April 2017
6-26
Table 1 Next level of menu
Display Notes
--BOOT MODE-- Used to clear corrupted jobs.
01. JOB LOG CLEAR
MODE
ARE YOU SURE?
YES
NO
--BOOT MODE--
02. FACTORY INIT MODE
ARE YOU SURE?
Do not perform this mode unless directed.
YES
NO Machine will be reset and the message
NVMEM IS CLEARED will be displayed.
Switch the machine off, then on,
Fault code 116-334 will be displayed, again
switch the machine off, then on,
code 124-315 will be displayed, perform
dC132. The machine will restart at the install
wizard.
All customer configured settings will be
deleted. To restore the customer configured
settings, a clone file is required. Refer to
13.
NOTE: . The install dongle will not be
required.
-BOOT MODE-- Forcibly initializes the controller NVM back to
03. NVRAM INIT MODE default. This is the same as initializing the
ARE YOU SURE? Sys - System NVM and Sys - User NVM in
YES dC301.
NO
-BOOT MODE-- All pending jobs will be deleted. The HDD will
04. HDD FORMAT MODE be forcibly reformatted.
ARE YOU SURE?
YES
NO
All customer data on the HDD (mailboxes,
scanned documents, user IDs and account
IDs) will be deleted.
--BOOT MODE-- All pending jobs will be deleted. The spool
06. HDD INITIALIZE area of the HDD will be initialized.
MODE
ARE YOU SURE?
YES
NO
All customer data on the HDD (mailboxes,
scanned documents, user IDs and account
IDs) will be deleted.
--BOOT MODE-- Starts the machine without displaying the
SKIP INSTALL WIZARD install wizard.
ARE YOU SURE?
YES
NO
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
CAUTION
GP 10.
GP 10. Fault
CAUTION
GP
CAUTION
CAUTION
Launch Issue