Display Poe Interface - H3C S3100 Series Command Manual

1
PoE Configuration Commands
PoE Configuration Commands

display poe interface

Syntax
display poe interface [ interface-type interface-number ]
View
Any view
Parameter
interface-type interface-number: Port type and port number.
Description
Use the display poe interface command to view the PoE status of a specific port or all ports of the
switch.
If the interface-type interface-number argument is not specified, the command displays the PoE status
of all ports of the switch.
Related commands: poe enable, poe max-power, poe mode, poe power-management, poe
priority.
Example
# Display the PoE status of Ethernet 1/0/10.
<Sysname> display poe interface Ethernet1/0/10
Port power enabled
Port power ON/OFF
Port power status
Port power mode
Port PD class
port power priority
Port max power
Port current power
Port peak power
Port average power
Port current
Port voltage
:enable
:on
:Standard PD was detected
:signal
:0
:low
:15400 mW
:460 mW
:552 mW
:547 mW
:10 mA
:51 V
1-1