Debugging Physical Poe - H3C MSR Series Probe Command Reference

isolationtable: Displays port isolation group information.
qosprofile: Displays QoS configuration information.
statistics: Displays statistics.
stptable: Displays STP table information.
vlanqos: Displays VLAN QoS configuration information.
all: Displays information about all entries.
cpld: Displays CPLD information.
global: Displays global register information.
mac: Displays MAC register information.
mactable: Displays MAC address table information.
vlantable: Displays VLAN entry information.
Usage guidelines
This command reads DUMP register information for the specified chip. It reads a group of DUMP register
values each time.

debugging physical poe

Use debugging physical poe to enable PoE module debugging.
Use undo debugging physical poe to disable PoE module debugging.
Syntax
debugging physical poe { all | error | event | packet }
undo debugging physical poe { all | error | event | packet }
Default
PoE module debugging is disabled.
Views
Probe view
Predefined user roles
network-admin
network-operator
Parameters
all: Specifies all types of debugging.
error: Specifies error debugging.
event: Specifies event debugging.
packet: Specifies packet debugging.
Usage guidelines
Outputting the debugging information affects system operation efficiency. When you diagnose a fault,
use this command to enable the specified debugging, rather than all types of debugging.
9