Setting To Output System Information To A Monitor Terminal - H3C S3100-52P Operation Manual

Operation Manual – Information Center
H3C S3100-52P Ethernet Switch
Note:
Make sure that the debugging/log/trap information terminal display function is enabled
(use the terminal monitor command) before you enable the corresponding terminal
display function by using the terminal debugging, terminal logging, or terminal
trapping command.

1.2.5 Setting to Output System Information to a Monitor Terminal

System information can also be output to a monitor terminal, which is a user terminal
that has login connections through the AUX, or VTY user interface.
I. Setting to output system information to a monitor terminal
Follow these steps to set to output system information to a monitor terminal
Enter system view
Enable the information
center
Enable system
information output to
Telnet terminal or dumb
terminal
Configure the output rules
of system information
Set the format of time
stamp in the output
information
To do...
system-view
info-center enable
info-center monitor
channel
{ channel-number |
channel-name }
info-center source
{ modu-name | default }
channel
{ channel-number |
channel-name } [ { log |
trap | debug } { level
severity | state state } ]*
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
Use the command...
1-12
Chapter 1 Information Center
Remarks
—
Optional
Enabled by default.
Optional
By default, a switch
outputs
log/debugging/trap
information to a user
terminal through
information channel 1.
Optional
Refer to Table 1-4 for the
default output rules of
system information.
Optional
By default, the time stamp
format of the log and trap
output information is date,
and that of the debugging
output information is
boot.