Lldp Management-Address-Tlv; Lldp Notification Remote-Change Enable - H3C S3100 Series Command Manual

[Sysname] lldp hold-multiplier 6

lldp management-address-tlv

Syntax
lldp management-address-tlv [ ip-address ]
undo lldp management-address-tlv
View
Ethernet interface view
Parameters
ip-address: Management address to be set.
Description
Use the lldp management-address-tlv command to enable the management address sending. This
command also sets the management address.
Use the undo lldp management-address-tlv command to disable management address sending.
By default, the management address is sent through LLDPDUs. The management address is the main
IP address of the lowest-ID VLAN carried on the port. If none of the carried VLANs is assigned an IP
address, no management address will be advertised.
Notes that:
An LLDPDU carries only one management address. If you set the management address
repeatedly, the latest one takes effect.
LLDP encodes management addresses in numeric format in management address TLVs. Make
sure that a neighbor also encodes its management address in numeric format to guarantee normal
communication with the neighbor.
Examples
# Set the management address to 192.6.0.1 for Ethernet1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] lldp management-address-tlv 192.6.0.1

lldp notification remote-change enable

Syntax
lldp notification remote-change enable
undo lldp notification remote-change enable
View
Ethernet interface view
Parameters
None
1-19