Static Pressure Sensor - Rotax 914 F Installation Manual

17.1) Static pressure sensor

See Ill. 47.
effective range:
deviation:
operating temperature: min.
dimensions and attachment:
fitting position:
The pressure connection (Pos. E Ill. 47) points downwards to prevent possible
condensate from entering the sensor, i.e. the longitudinal axis z4 has to be parallel
to z-axis in system of coordinates.
tolerated deviation of parallelism ± 60°
location of installation:
vibration neutralized installation in a calm zone, e.g. in cockpit.
In the area of the pressure pick-up approx. the same atmospheric pressure (static
air pressure) has to prevail as at inlet of turbo charger.
ATTENTION: The pressure connection has to be protected against entering of
NOTE:
length of cable assy.: approx. 250 mm (10 in) from TCU.
Date
Page
1996 05 10
68
100 ÷ 1200 hPa
max. ± 40 hPa
max.
foreign matter e.g. oil, fuel, water etc.
Location of installation is limited by the length of the wiring harness.
ø3
ø4,7
60°
21
Install
914 F
- 40° C (-40° F)
+125° C (257° F)
see sketch (Ill. 47)
+z4
3
60°
-z4
24
Ill. 47
Reference Modification-No.
- 0 -