D-Link DXS-3600 Series Cli Reference Manual page 374

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
22-32 vrf (DHCP Pool)
This command is used to associate the address pool with a VRF name.
vrf VRF-NAME
no vrf VRF-NAME
Parameters
VRF-NAME
Default
None.
Command Mode
DHCP Pool Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
By default, the address pool is defined for the global routing domain. Associating a pool with a VRF
allows overlapping addresses of other pools that are not on the same VRF. Only one pool can be
associated with each VRF. If the address pool is associated with a VRF, the DHCP server will only assign
an IP address from the address pool when the associated VRF matches the VRF of the DHCP request.
Example
This example shows how to associate the on-demand address pool with a VRF named pool1.
Switch# configure terminal
Switch(config)# ip dhcp pool pool1
Switch(config-dhcp-pool)# vrf pool1
Switch(config-dhcp-pool)#
Specifies the name of the VRF to which the address pool is associated
with.
369