Auth Timeout Server-Timeout - Allied Telesis x510-28GTX Command Reference Manual

A C
UTHENTICATION OMMANDS
-
AUTH TIMEOUT SERVER TIMEOUT

auth timeout server-timeout

Overview This command sets the timeout for the waiting response from the RADIUS server
on a given interface.
The no variant of this command resets the server-timeout to the default (30
seconds).
Syntax auth timeout server-timeout <1-65535>
no auth timeout server-timeout
Default The server timeout for port authentication is 30 seconds.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
To set the server timeout to 120 seconds for interface port1.0.2, use the
Examples
following commands:
awplus#
awplus(config)#
awplus(config-if)#
To set the server timeout to the default (30 seconds) for interface port1.0.2, use
the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To set the server timeout to 120 seconds for authentication profile 'student', use
the commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
To set the server timeout to the default (30 seconds) for authentication profile
'student', use the commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
C613-50170-01 Rev B
Parameter
<1-65535>
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
configure terminal
auth profile student
configure terminal
auth profile student
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Server timeout period (in seconds).
auth timeout server-timeout 120
no auth timeout server-timeout
auth timeout server-timeout 120
no auth timeout server-timeout
1752