Ip Pim Jp-Timer - Allied Telesis x510-28GTX Command Reference Manual

PIM-SM C
OMMANDS
-
IP PIM JP TIMER

ip pim jp-timer

Overview Use this command to set the PIM-SM join/prune timer. Note that the value the
device puts into the holdtime field of the join/prune packets it sends to its
neighbors is 3.5 times the join/prune timer value set using this command.
Use the no variant of this command to return the PIM-SM join/prune timer to its
default value of 60 seconds, which corresponds to a join/prune packet holdtime of
210 seconds.
ip pim jp-timer <1-65535>
Syntax
no ip pim jp-timer [<1-65535>]
Default The default join/prune timer value is 60 seconds.
Mode Global Configuration
Example To set the join/prune timer value to 300 seconds, use the commands:
awplus#
awplus(config)#
To return the join/prune timer to its default value of 60 seconds, use the
commands:
awplus#
awplus(config)#
C613-50170-01 Rev B
Parameter Description
<1-65535>
Specifies the join/prune timer value. The default value is 60 seconds.
configure terminal
ip pim jp-timer 300
configure terminal
no ip pim jp-timer
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
1340