Show Ip Pim Sparse-Mode Mroute - Allied Telesis x510-28GTX Command Reference Manual

PIM-SM C
OMMANDS
-
SHOW IP PIM SPARSE MODE MROUTE

show ip pim sparse-mode mroute

Overview Use this command to display the IP multicast routing table or the IP multicast
routing table based on a specific address or addresses.
show ip pim sparse-mode mroute [<group-address>]
Syntax
show ip pim sparse-mode mroute [<source-address>]
show ip pim sparse-mode mroute [<source-address>
<group-address>]
Mode Privileged Exec
Usage Note that when a feature license is enabled, the output for the show ip pim
sparse-mode mroute command will only show 32 interfaces because of the
terminal display width limit. Use the show ip pim sparse-mode mroute detail
command to display detailed entries of the IP multicast routing table.
Example To display the IP multicast routing table for the address 40. 40. 40.11, enter the
command:
awplus#
C613-50170-01 Rev B
Parameter
<group-address>
<source-address>
show ip pim sparse-mode mroute 40.40.40.11
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Group IP address, entered in the form A.B.C.D. Output is all
multicast entries belonging to that group.
Source IP address, entered in the form A.B.C.D. Output is all
multicast entries belonging to that source.
1361