Stack Virtual-Mac - Allied Telesis x510-28GTX Command Reference Manual

V C S (VCS
IRTUAL HASSIS TACKING
-
STACK VIRTUAL MAC

stack virtual-mac

Overview This command enables the stack virtual MAC address feature. For more
information on this topic, see the
Guide. With this command set, the value used as the virtual MAC address is
determined by the setting of the command
You must enable stack virtual-mac, in order to minimize data loss if a new stack
member is required to become the VCStack master.
Before enabling the virtual MAC address feature, you should check that the stack's
virtual-chassis-id is not already used by another stack in the network. Otherwise
the duplicate MAC addresses will cause problems for the network traffic.
stack virtual-mac
Syntax
no stack virtual-mac
Default The stack virtual MAC address feature is disabled by default. However, if you
manually turn on stacking (by entering the stack enable command), then that
enables the stack virtual MAC address feature as well.
Mode Global Configuration
Usage Note that this command will not take effect until the switch has been rebooted.
awplus#
Example
awplus(config)#
Related show running-config
Commands
show stack
switch provision (stack)
stack virtual-chassis-id
C613-50170-01 Rev B
™) C
TACK OMMANDS
configure terminal
stack virtual-mac
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
VCStack Feature Overview and Configuration
stack virtual-chassis-id.
2101