Clear Ip Mroute - Allied Telesis x510-28GTX Command Reference Manual

M C
ULTICAST OMMANDS

CLEAR IP MROUTE

clear ip mroute
Overview Use this command to delete entries from the IPv4 multicast routing table.
NOTE
to clear IGMP group membership records.
Syntax clear ip mroute {*|<ipv4-group-address>
[<ipv4-source-address>]} [pim sparse-mode]
Mode Privileged Exec
Usage When this command is used, the Multicast Routing Information Base (MRIB) clears
the IPv4 multicast route entries in its IPv4 multicast route table, and removes the
entries from the multicast forwarder. The MRIB sends a "clear" message to the
multicast protocols. Each multicast protocol has its own "clear" multicast route
command. The protocol-specific "clear" command clears multicast routes from
PIM Sparse Mode, and also clears the routes from the MRIB.
awplus#
Examples
awplus#
Related ip multicast route
Commands
show ip mroute
C613-50170-01 Rev B
: If you use this command, you should also use the
Parameter Description
*
Deletes all multicast routes.
<ipv4-group-
Group IPv4 address, in dotted decimal notation in the format
address>
A.B.C.D.
<ipv4-source-
Source IPv4 address, in dotted decimal notation in the format
address>
A.B.C.D.
pim sparse-mode Clear specified IPv4 multicast route(s) for PIM Sparse Mode only.
clear ip mroute 225.1.1.1 192.168.3.3
clear ip mroute *
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
clear ip igmp group command
1286