Ip Pim Ext-Srcs-Directly-Connected - Allied Telesis x510-28GTX Command Reference Manual

PIM-SM C
OMMANDS
- - -
IP PIM EXT SRCS DIRECTLY CONNECTED

ip pim ext-srcs-directly-connected

Overview Use this command to configure PIM to treat all source traffic arriving on the
interface as though it was sent from a host directly connected to the interface.
Use the no variant of this command to configure PIM to treat only directly
connected sources as directly connected.
Syntax ip pim ext-srcs-directly-connected
no ip pim ext-srcs-directly-connected
Default The no variant of this command is the default behavior.
Mode Interface Configuration for a VLAN interface.
Example To configure PIM to treat all sources as directly connected for VLAN interface vlan2,
use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To configure PIM to treat only directly connected sources as directly connected for
VLAN interface vlan2, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50170-01 Rev B
configure terminal
interface vlan2
ip pim ext-srcs-directly-connected
configure terminal
interface vlan2
no ip pim ext-srcs-directly-connected
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
1336