Atmf Area Password - Allied Telesis x510-28GTX Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT

ATMF AREA PASSWORD

atmf area password
Overview This command sets a password on an AMF area.
Use the no variant of this command to remove the password.
This command is only valid on AMF controllers, master nodes and gateway nodes.
The area name must have been configured first.
atmf area <area-name> password [8] <password>
Syntax
no atmf area <area-name> password
Mode Global Configuration
Usage You must configure a password on each area that an AMF controller
communicates with, except for the controller's local area. The areas must already
have been created using the
Enter the password identically on both of:
•
•
The command show running-config atmf will display the encrypted version of
this password. The encryption keys will match between the controller and the
remote AMF master.
If multiple controller and masters exist in an area, they must all have the same area
configuration.
Example To give the AMF area named Auckland a password of "secure#1" use the following
command on the controller:
controller-1(config)#
and also use the following command on the master node for the Auckland area:
auck-master(config)#
C613-50170-01 Rev B
™ (AMF) C
RAMEWORK OMMANDS
Parameter
<area-name>
8
<password>
the area that locally contains the controller, and
the remote AMF area masters
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
The AMF area name.
This parameter is displayed in show running-config
output to indicate that it is displaying the password in
encrypted form. You should not enter 8 on the CLI
yourself.
The password is between 8 and 32 characters long. It
can include spaces.
atmf area command.
atmf area Auckland password secure#1
atmf area Auckland password secure#1
2227