Openflow Inactivity - Allied Telesis x510-28GTX Command Reference Manual

O F C
PEN LOW OMMANDS

OPENFLOW INACTIVITY

openflow inactivity
Overview Use this command to set the value of the Controller inactivity timeout.
Use the no variant of this command to reset the inactivity timeout value to its
default.
Syntax openflow inactivity <5-2073600>
no openflow inactivity
Default 10 seconds.
Mode Global Configuration
Usage OpenFlow uses the inactivity probe timer to monitor its connection to
Controller(s). If no message is received from any Controller for three times the
inactivity probe interval, then OpenFlow will take over responsibility for setting up
flows, if in standalone mode.
Example To configure the inactivity probe timeout to 20 seconds, enter the commands:
awplus#
awplus(config)#
To reset the inactivity probe timeout to its default value of 10 seconds, enter the
commands:
awplus#
awplus(config)#
Related openflow controller
Commands
Command Version 5.4.7-1.1: command added.
changes
C613-50170-01 Rev B
Parameter Description
<5-2073600>
Specifies the timeout value in seconds
inactivity OpenFlow inactivity probe
configure terminal
openflow inactivity 20
configure terminal
no openflow inactivity
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
2044